Fujitsu FI-5530C2 Руководство по началу работы - Страница 8

Просмотреть онлайн или скачать pdf Руководство по началу работы для Сканер Fujitsu FI-5530C2. Fujitsu FI-5530C2 11 страниц. Image scanner
Также для Fujitsu FI-5530C2: Начало работы (28 страниц), Руководство по процедурам установки (6 страниц), Технические характеристики (2 страниц), Руководство по началу работы (27 страниц), Инструкции по очистке (2 страниц), Инструкции по очистке (2 страниц), Начало работы (11 страниц)

Печатать страницу
Fujitsu FI-5530C2 Руководство по началу работы
Installation (Custom)
1. Perform steps 1. to 3. in
mended)" (page.
2. Click the [Installation (Custom)] button.
3. Select the check box for the software to install
and click the [Next] button.
4. Follow the instructions on the screen to pro-
ceed with the installation.
"Installation (Recom-
7).
2.4 Checking Scanner Driver
Operation
This section explains how to check the operation of the
installed scanner driver by using ScandAll PRO.
For details about scanning documents by using Paper-
Stream Capture and the PaperStream IP driver, refer to
the help of each software.
Make sure that the scanner driver is installed properly,
following the procedure below.
■ Checking the Operation of the

Scanner Driver

1. Load the document on the scanner.
For information about how to load the document,
refer to section 1.2 in fi-5530C2 Operator's
Guide.
2. Launch ScandAll PRO.
From the [start] menu, select [All Programs] ->
[Fujitsu ScandAll PRO] -> [ScandAll PRO].
⇒
ScandAll PRO starts up.
3. In ScandAll PRO, select [Tool] on the menu,
and then select [Preferences].
⇒
The [Setup] dialog box appears.
4. On the [Scan] tab, select a driver.
To check the operation of TWAIN, select
[TWAIN].
To check the operation of ISIS, select [ISIS].
5. Click the [OK] button to close the [Setup] dialog
box.
6. In ScandAll PRO, select [Scan] on the menu,
and then select [Select Scanner].
7. Select a scanner in the displayed dialog box.
To use TWAIN:
Select [FUJITSU fi-5530C2dj], and then click the
[Select] button.
To use ISIS:
Select [Fujitsu fi-5530C2] and then click the
[Select] button.
8. Select [Scan] on the menu, and then select
[Scan Settings].
8