Fujitsu FI-5530C2 Manual de iniciação - Página 8

Procurar online ou descarregar pdf Manual de iniciação para Scanner Fujitsu FI-5530C2. Fujitsu FI-5530C2 11 páginas. Image scanner
Também para Fujitsu FI-5530C2: Começar a trabalhar (28 páginas), Manual de procedimentos de instalação (6 páginas), Especificações (2 páginas), Manual de iniciação (27 páginas), Instruções de limpeza (2 páginas), Instruções de limpeza (2 páginas), Começar a trabalhar (11 páginas)

Imprimir página

Installation (Custom)

1. Perform steps 1. to 3. in

mended)" (page.

2. Click the [Installation (Custom)] button.

3. Select the check box for the software to install

and click the [Next] button.

4. Follow the instructions on the screen to pro-

ceed with the installation.

"Installation (Recom-

7).

2.4 Checking Scanner Driver

Operation

This section explains how to check the operation of the

installed scanner driver by using ScandAll PRO.

For details about scanning documents by using Paper-

Stream Capture and the PaperStream IP driver, refer to

the help of each software.

Make sure that the scanner driver is installed properly,

following the procedure below.

■ Checking the Operation of the

Scanner Driver

1. Load the document on the scanner.

For information about how to load the document,

refer to section 1.2 in fi-5530C2 Operator's

Guide.

2. Launch ScandAll PRO.

From the [start] menu, select [All Programs] ->

[Fujitsu ScandAll PRO] -> [ScandAll PRO].

⇒

ScandAll PRO starts up.

3. In ScandAll PRO, select [Tool] on the menu,

and then select [Preferences].

⇒

The [Setup] dialog box appears.

4. On the [Scan] tab, select a driver.

To check the operation of TWAIN, select

[TWAIN].

To check the operation of ISIS, select [ISIS].

5. Click the [OK] button to close the [Setup] dialog

box.

6. In ScandAll PRO, select [Scan] on the menu,

and then select [Select Scanner].

7. Select a scanner in the displayed dialog box.

To use TWAIN:

Select [FUJITSU fi-5530C2dj], and then click the

[Select] button.

To use ISIS:

Select [Fujitsu fi-5530C2] and then click the

[Select] button.

8. Select [Scan] on the menu, and then select

[Scan Settings].