Fujitsu FI-5530C2 Panduan Memulai - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Memulai untuk Pemindai Fujitsu FI-5530C2. Fujitsu FI-5530C2 11 halaman. Image scanner
Juga untuk Fujitsu FI-5530C2: Memulai (28 halaman), Manual Prosedur Instalasi (6 halaman), Spesifikasi (2 halaman), Panduan Memulai (27 halaman), Petunjuk Pembersihan (2 halaman), Petunjuk Pembersihan (2 halaman), Memulai (11 halaman)

Halaman Cetak

Installation (Custom)

1. Perform steps 1. to 3. in

mended)" (page.

2. Click the [Installation (Custom)] button.

3. Select the check box for the software to install

and click the [Next] button.

4. Follow the instructions on the screen to pro-

ceed with the installation.

"Installation (Recom-

7).

2.4 Checking Scanner Driver

Operation

This section explains how to check the operation of the

installed scanner driver by using ScandAll PRO.

For details about scanning documents by using Paper-

Stream Capture and the PaperStream IP driver, refer to

the help of each software.

Make sure that the scanner driver is installed properly,

following the procedure below.

■ Checking the Operation of the

Scanner Driver

1. Load the document on the scanner.

For information about how to load the document,

refer to section 1.2 in fi-5530C2 Operator's

Guide.

2. Launch ScandAll PRO.

From the [start] menu, select [All Programs] ->

[Fujitsu ScandAll PRO] -> [ScandAll PRO].

⇒

ScandAll PRO starts up.

3. In ScandAll PRO, select [Tool] on the menu,

and then select [Preferences].

⇒

The [Setup] dialog box appears.

4. On the [Scan] tab, select a driver.

To check the operation of TWAIN, select

[TWAIN].

To check the operation of ISIS, select [ISIS].

5. Click the [OK] button to close the [Setup] dialog

box.

6. In ScandAll PRO, select [Scan] on the menu,

and then select [Select Scanner].

7. Select a scanner in the displayed dialog box.

To use TWAIN:

Select [FUJITSU fi-5530C2dj], and then click the

[Select] button.

To use ISIS:

Select [Fujitsu fi-5530C2] and then click the

[Select] button.

8. Select [Scan] on the menu, and then select

[Scan Settings].