- ページ 5

温度コントローラー Auber Instruments WS SeriesのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Auber Instruments WS Series 18 ページ。 Programmable pid temperature controller with dual probe
Auber Instruments WS Series にも：クイックマニュアル (15 ページ), クイックマニュアル (14 ページ), 取扱説明書 (18 ページ), クイックマニュアル (14 ページ)

ページを印刷する

The connection of the controller should be done in the following steps.

 Plug the temperature sensor to the back of the controller.

 Plug the power cord to the power outlet on the wall.

 Turn on the controller to make sure the controller powers up properly and the

temperature display is in the range expected. Then, turn off the controller.

 Plug the heater to the back of the controller. If the heater has a switch, put it in the

off position. Put the sensor inside the container to be controlled.

 Turn on the controller.

 Turn on the heating device.

Remark The connector of sensor contains a slot for correct pin connection. It also has a

spring lock to prevent disconnections from accidental pulling on the cable. The following

pictures show how to install and remove it.

Fig 3a. How to install the sensor.