Auber Instruments WS Series 작동 및 사용 설명서 - 페이지 5

{카테고리_이름} Auber Instruments WS Series에 대한 작동 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Auber Instruments WS Series 18 페이지. Programmable pid temperature controller with dual probe
Auber Instruments WS Series에 대해서도 마찬가지입니다: 빠른 매뉴얼 (15 페이지), 빠른 매뉴얼 (14 페이지), 작동 및 사용 설명서 (18 페이지), 빠른 매뉴얼 (14 페이지)

페이지 인쇄

The connection of the controller should be done in the following steps.

 Plug the temperature sensor to the back of the controller.

 Plug the power cord to the power outlet on the wall.

 Turn on the controller to make sure the controller powers up properly and the

temperature display is in the range expected. Then, turn off the controller.

 Plug the heater to the back of the controller. If the heater has a switch, put it in the

off position. Put the sensor inside the container to be controlled.

 Turn on the controller.

 Turn on the heating device.

Remark The connector of sensor contains a slot for correct pin connection. It also has a

spring lock to prevent disconnections from accidental pulling on the cable. The following

pictures show how to install and remove it.

Fig 3a. How to install the sensor.