Auber Instruments WS Series Manual de operação e instruções - Página 5
Procurar online ou descarregar pdf Manual de operação e instruções para Controlador de temperatura Auber Instruments WS Series. Auber Instruments WS Series 18 páginas. Programmable pid temperature controller with dual probe
Também para Auber Instruments WS Series: Manual rápido (15 páginas), Manual rápido (14 páginas), Manual de operação e instruções (18 páginas), Manual rápido (14 páginas)
Imprimir página
The connection of the controller should be done in the following steps.
Plug the temperature sensor to the back of the controller.
Plug the power cord to the power outlet on the wall.
Turn on the controller to make sure the controller powers up properly and the
temperature display is in the range expected. Then, turn off the controller.
Plug the heater to the back of the controller. If the heater has a switch, put it in the
off position. Put the sensor inside the container to be controlled.
Turn on the controller.
Turn on the heating device.
Remark The connector of sensor contains a slot for correct pin connection. It also has a
spring lock to prevent disconnections from accidental pulling on the cable. The following
pictures show how to install and remove it.
Fig 3a. How to install the sensor.
5