- ページ 6

電源 ADELSYSTEM CBI-1280 SeriesのPDF マニュアルをオンラインで閲覧またはダウンロードできます。ADELSYSTEM CBI-1280 Series 11 ページ。 All in one dc ups power solutions

ページを印刷する

Option "4"

Note (1):

In Ni-Cd. The End-of-charge is determined by negative ∆V detection of battery voltage (-5mV/cell). If no negative ∆V but

only a "flat" profile is detected fast charge is terminated after 10 min. General end-of-charge timeout set to 16 hours.

Trickle charge current is regulated at 10% of max current set by the trimmer on the front panel in position N°5. In order

to detect end-of-charge negative ∆V, charging current must be set at least at 30% of nominal battery capacity (0,3 C);

with lower values of charging current negative ∆V detection is not guaranteed.

Jumper Setting always active during all states of the system.

Functional Setting

Battery LIFE TEST

Caution: Switch off the system before Setting the Jumper.

Functional Setting

ENABLE POWER

SUPPLY

ENABLE POWER SUPPLY function

With this feature enabled, there is always voltage on the Output BATTERY even if is the battery is not present, in this

way you don't have voltage dips, the Battery Care is guaranteed but the controls on the battery are limited.

Be careful: don't reverse the battery polarity.

No. 19: Other Battery Management Configurations

Jumper Setting always active during all states of the system.

Functional Setting

FAST CHARGE

Enable

OPTION

No. 18: SELECTION OUT VOLTAGE

Caution: Switch off the system before Setting the Jumper.

Functional Setting

Output Voltage

selection

Output Voltage

selection

BATTERY TYPE

Do not use other configurations for Battery Management

LIFE TEST

ENABLE POWERSUPPLY

12 Vdc

24 Vdc

Function

ON position = LIFE TEST enabled

Function

ON position = function POWER SUPPLY

enabled

Function

Fast charge enabled. Only for Lead or Gel

battery.

Future implementation

Function

12V Output Voltage

24V Output Voltage

Default setting