- ページ 13

レシーバー e-survey E500のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。e-survey E500 19 ページ。
e-survey E500 にも：マニュアル (19 ページ)

3.5.2 MEMS Tilt Survey

When MEMS sensor is activated on E500. To calibrate the MEMS sensor, receiver

must be in Fixed solution. In SurPad4.0 software, connect device and click "Device" ->

"Device Settings", enable "Pole Tilt Correction" function. Then, go to "Survey" ->

"Point Survey" page. The software will guide user to calibrate the sensor.

•

Input the correct pole height

•

Draw circle on the ground using the pole

•

Follow the guide and shake the pole back and forth for around 5-10 seconds or

walk in straight line around 10 meters until it shows "Ready"

Web:

www.esurvey-gnss.com

E500 User Manual