- ページ 13

スイッチ DIS Sensors QG40NのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。DIS Sensors QG40N 15 ページ。 Tilt/acceleration switch (sil1 plc)
DIS Sensors QG40N にも： ユーザーマニュアル (5 ページ), 取扱説明書 (6 ページ)

ページを印刷する
DIS Sensors QG40N ユーザーマニュアル

Mounting

Figure 8 - Horizontal mounting 2-axis
• The sensor should be mounted on a stable flat surface with at least two screws tightened.
• Never move the sensor by pulling the cable.
• A 1-axis tilt switch must be mounted vertically. The factory default zero position is with the
male connector pointing down as shown in Figure 3. The sensor can be zero adjusted at any
position within the full range.
• A 2-axis tilt switch must be mounted horizontally. The factory default zero position is shown
in Figure 2. After installation, the sensor can be zero adjusted to eliminate the mechanical
offsets within a ±5° offset range.
DIS SENSORS BV
User Manual - QG40N Tilt/Acceleration Switch (SIL1 PLc) V2.0
Figure 7 - Mechanical drawing of QG40N with a male M12
Figure 9 Vertical mounting 1-axis
12