DIS Sensors QG40N Kullanıcı Kılavuzu - Sayfa 13

Anahtar DIS Sensors QG40N için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. DIS Sensors QG40N 15 sayfaları. Tilt/acceleration switch (sil1 plc)
Ayrıca DIS Sensors QG40N için: Kullanıcı Kılavuzu (5 sayfalar), Kullanım ve Güvenlik Kılavuzu (6 sayfalar)

Sayfayı Yazdır
DIS Sensors QG40N Kullanıcı Kılavuzu

Mounting

Figure 8 - Horizontal mounting 2-axis
• The sensor should be mounted on a stable flat surface with at least two screws tightened.
• Never move the sensor by pulling the cable.
• A 1-axis tilt switch must be mounted vertically. The factory default zero position is with the
male connector pointing down as shown in Figure 3. The sensor can be zero adjusted at any
position within the full range.
• A 2-axis tilt switch must be mounted horizontally. The factory default zero position is shown
in Figure 2. After installation, the sensor can be zero adjusted to eliminate the mechanical
offsets within a ±5° offset range.
DIS SENSORS BV
User Manual - QG40N Tilt/Acceleration Switch (SIL1 PLc) V2.0
Figure 7 - Mechanical drawing of QG40N with a male M12
Figure 9 Vertical mounting 1-axis
12