DIS Sensors QG40N 사용자 설명서 - 페이지 13

{카테고리_이름} DIS Sensors QG40N에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DIS Sensors QG40N 15 페이지. Tilt/acceleration switch (sil1 plc)
DIS Sensors QG40N에 대해서도 마찬가지입니다: 사용자 설명서 (5 페이지), 사용자 및 안전 매뉴얼 (6 페이지)

페이지 인쇄
DIS Sensors QG40N 사용자 설명서

Mounting

Figure 8 - Horizontal mounting 2-axis
• The sensor should be mounted on a stable flat surface with at least two screws tightened.
• Never move the sensor by pulling the cable.
• A 1-axis tilt switch must be mounted vertically. The factory default zero position is with the
male connector pointing down as shown in Figure 3. The sensor can be zero adjusted at any
position within the full range.
• A 2-axis tilt switch must be mounted horizontally. The factory default zero position is shown
in Figure 2. After installation, the sensor can be zero adjusted to eliminate the mechanical
offsets within a ±5° offset range.
DIS SENSORS BV
User Manual - QG40N Tilt/Acceleration Switch (SIL1 PLc) V2.0
Figure 7 - Mechanical drawing of QG40N with a male M12
Figure 9 Vertical mounting 1-axis
12