Anyload EC200 운영 매뉴얼 - 페이지 13

{카테고리_이름} Anyload EC200에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Anyload EC200 16 페이지.
Anyload EC200에 대해서도 마찬가지입니다: 사용자 설명서 (8 페이지)

- If necessary, press ZERO key to set the display to "0"

- Press QTY/SET key, display will show CH=OFF or CH=ON

- Press the ENTER key to select "ON"

- Press [*] key, display will show a flashing "0" at UNIT WEIGHT, key in the lower limit using

the numeric key pad, press [*] gain, display will show a flashing "0" at TOTAL, key in the upper

limit using the numeric keypad.

-Press QTY/SET key to confirm the setting and return to weighing mode.

- Press the SCALE/SELECT key to select either SCALE 1 or SCALE 3, be sure to place

the additional pieces on the scale that is selected.

***NOTE: When adding items onto the scale, the scale will beep in a particular tone if the

weight (number of items) is less than the lower limit and beep in another tone if it is higher than

the upper limit.

5 Calibration - Using an External Calibration Weight:

Calibration is required when the weighing machine is initially installed or if the scale is moved to a

substantial distance from the original location. 10 minutes warm up of scale is always needed before

calibration.

5.1 Scale 1 Calibration

- Turn on scale

- As the scale is counting down, press the following buttons in order [1], [3], [1], [1]

then press ENTER

- Display will show the following: 'WEIGHT DISPLAY' shows SCALE 1, 'UNIT WEIGHT'

shows CAL-0, 'TOTAL DISPLAY' will show A/D value

- Press UNIT key to select whether you will calibrate in kg or lb

- Press ENTER to set zero point (UNIT WEIGHT will show CAL-0 flashing for a

few seconds and then changes to XXXX to set the calibration weight)

- Press [CE] key and then press the corresponding number buttons based off of the

amount of weight you are using to calibrate (example: if you are using 5lbs to calibrate the

scale you would key in 5lbs).

- Calibration weight will show in the UNIT WEIGHT display.

- Press the ENTER key, the UNIT WEIGHT display will show flashing XX and then

changes to XX.XXX lb. Once this occurs the calibration process is complete.

Page 13 of 16

AL-manual-EC200-En-V2