Siemens SIPART PS2 설치 지침 - 페이지 2

{카테고리_이름} Siemens SIPART PS2에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIPART PS2 4 페이지. Mounting bracket kit
Siemens SIPART PS2에 대해서도 마찬가지입니다: 사용 설명서 (28 페이지), 설치 지침 (4 페이지), 하드웨어 설치 매뉴얼 (30 페이지), 기술 설명 (26 페이지), 간결한 사용 설명서 (35 페이지), 키트 설치 지침 (9 페이지), 설치 지침 (11 페이지)

페이지 인쇄

15900-766

PARTS, KIT 16152-665

Description

Manifold

Standoff (for Linkage U)

Feedback Pin (for Linkage P)

O-Ring

M8 x 25 Socket Hd. Cap Screw

M8 Split Lockwasher

M6 x 35 Low Socket Hd. Cap Screw

M6 Split Lockwasher

1/4 NPT Pipe Plug

G1/4 Pipe Plug

INSTALLATION

Refer to the following procedure and to the positioner and actuator installation instructions while

performing the installation. The current revision of the positioner instruction

Internet site. See Customer/Product Support later in this Instruction for the URL.

Before beginning the installation, note the following cautions.

CAUTION

Two installations are described below: Linkage P and Linkage U. Feedback linkage components differ

and this affects the installation procedure, as indicated in several steps below.

1. Open the supplied kits and check the included parts against the above parts list and the drawing on

page 1. Note whether feedback linkage components are for a Linkage P or Linkage U installation; see

the exploded view drawing on page 1.

2. Mount the manifold on the actuator – Place an O-ring in the recess in the manifold and use two M8 x

25 socket head screws to secure the manifold to the actuator.

3. Mount feedback parts on the actuator:

•

Linkage P – Thread the feedback pin into the stem block. Do not tighten at this time.

•

Linkage U – Fasten the standoff, V-blocks, and U-channel to the stem block using two supplied

M8 x 12 socket head screws and lockwashers. Do not tighten at this time.

4. Mount feedback parts on the positioner:

•

Linkage P – 1) Insert the threaded end of the linear adapter into

the rectangular hole in the feedback lever; see detail at right.

Install and tighten the supplied nut and lockwasher. Note: Ignore

the text on the feedback lever. 2) Place the linear adapter on the

positioner input shaft and tighten the adapter setscrew on the

flat on the shaft. If desired, a small amount of thread locking

solution can be placed on the setscrew threads.

PS2: SIPART PS2 Electropneumatic Positioners for Linear and Rotary Actuators, P/N A5E00074631

Do not apply supply pressure to the actuator or the valve

positioner during the installation process. Applying supply

pressure before the equipment is properly mounted could cause

unexpected movement that could lead to personal injury or

equipment damage.

Do not exceed the maximum actuator and valve positioner air

pressures stated in the manufacturer's literature. Exceeding

these ratings could cause personal injury or equipment damage.

Quantity

is available at the Siemens

Adapter setscrew

on far side for

easier access.