Siemens SIPART PS2 설치 지침 - 페이지 3

{카테고리_이름} Siemens SIPART PS2에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIPART PS2 4 페이지. Mounting bracket kit
Siemens SIPART PS2에 대해서도 마찬가지입니다: 사용 설명서 (28 페이지), 설치 지침 (4 페이지), 하드웨어 설치 매뉴얼 (30 페이지), 기술 설명 (26 페이지), 간결한 사용 설명서 (35 페이지), 키트 설치 지침 (9 페이지), 설치 지침 (11 페이지)

•

Linkage U – 1) Place the feedback lever on the positioner input shaft and tighten the clamp

screw. 2) Insert the threaded end of the feedback pin into the feedback lever slot and loosely

secure the pin with the supplied nut and lockwasher.

5. Plug the positioner Y1 port – Select a compatible pipe plug: 1/4 NPT or G1/4. Place a small amount

of non-hardening pipe sealing compound on the threads of the 1/4 NPT plug. Refer to the drawing

below and thread the selected plug into the Y1 port.

A single-acting position is recommended for this application. A double acting

positioner (with Y2 port) is not recommended.

6. Remove the factory-installed Y1 sealing screw and O-ring – Refer to the drawing below and use a

TORX® wrench to remove the sealing screw and O-ring from the back of the positioner.

7. Linkage P – Size the feedback pin:

1) Refer to the figure on page 1 and orient the positioner to the actuator as shown.

2) Place the positioner against the manifold.

3) Rotate the feedback lever against the feedback pin and measure the length of pin that extends

beyond the lever. The pin must extend beyond the lever by a minimum of 1/8" but must not

contact the positioner or any other item throughout its range of motion.

4) If the pin must be shortened, mark the pin where it is to be cut and remove the pin from the

actuator. Cut the pin to length and remove any burs from the cut end; a slight bevel will make

inserting the pin into the lever slot easier. Do not score the pin where it will ride in the feedback

lever slot.

5) Thread the pin into the stem block and tighten.

Note

1. Y1 Port, actuating pressure

2. Positioner input shaft

3. P

Port, Supply air

4. n/a

5. Exhaust air outlet

15900-766