3D Systems Cubify CUBEX Duo 매뉴얼 - 페이지 6

{카테고리_이름} 3D Systems Cubify CUBEX Duo에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Systems Cubify CUBEX Duo 10 페이지. Replacing a main board pcb
3D Systems Cubify CUBEX Duo에 대해서도 마찬가지입니다: 교체 매뉴얼 (13 페이지), 교체 매뉴얼 (17 페이지), 매뉴얼 (10 페이지)

페이지 인쇄
3D Systems Cubify CUBEX Duo 매뉴얼

Voltage Measurement Locations

Depending which stepper motor chip voltage you want to read, you will need to
position your multimeter in different positions of the board. You will need to place a
small screwdriver with one end of the multimeter clipped onto it on the small screw
head labelled TP – and another end of the multimeter will need to be set to ground
on the board.
TP X will measure the voltage for the X axis.
TP Y will measure the voltage for the Y axis.
TP Z will measure the voltage for the Z axis.
TP E1, TP E2 and TP E3 will measure the voltage for print jets 1, 2 and 3.
TP Y
TP X
TP Z
Ground
6