DNP DS40 유지 관리 매뉴얼 - 페이지 5
{카테고리_이름} DNP DS40에 대한 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DNP DS40 6 페이지. Photo imaging
DNP DS40에 대해서도 마찬가지입니다: 빠른 참조 (6 페이지), 빠른 시작 매뉴얼 (8 페이지), 재포장 매뉴얼 (2 페이지)
페이지 인쇄
Paper Jam
1.
Open the Front panel as per changing paper instructions &
remove the ribbon tray.
2.
You should be able to see the jammed paper feed below
where the ribbon tray was mounted. Gently pull the paper
upwards until the jammed paper is released & you can see
smooth, undamaged paper feeding through the feed (Figure
7).
3.
Cut the damaged paper away, ensuring the cut is a straight
as possible.
4.
Remove & rewind the paper spool as per instruction for
changing the paper roll & reset the paper as per normal
process.
Ribbon Jam
1.
Remove the ribbon cartridge as per instructions for changing a ribbon & cut the
ribbon to free the main ribbon & cartridge (Figure 8).
2.
Carefully pull the remaining jammed ribbon from the printer ensuring that no
remnants of the ribbon remain stuck as this will impact ongoing printing (Figure 9).
3.
Use clear sticky tape to join the cut ends of the ribbon remaining in the cartridge
& then wind the ribbon onto the take up/waste spool until the tape is out of sight
(Figure 10). We would suggest a minimum of 1 full 'set' of ribbon colours is wound
on.
Figure 8 - Cutting the
ribbon
Figure 9 - gently pull
dam aged ribbon from printer
Figure 7 - Removal of
jammed paper
Figure 10 - Direction to wind
dam aged ribbon onto spool