21st Century Alarms LuxHome LCD Podręcznik użytkownika - Strona 2

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla System bezpieczeństwa 21st Century Alarms LuxHome LCD. 21st Century Alarms LuxHome LCD 7 stron. Wireless alarm system

Drukuj stronę
03 - Part-Arm 2
The system can be set in Part-Arm 2 mode using either the Remote Control or the Control Panel
as follows:
Remote Control: Press the 'PART-ARM' button twice:
?
?
?
?
?
,
,
Control Panel:
User Access
Access Code
By pressing
button, the programmed exit delay will be overrided to 5 seconds.

04 - Disarm

The system can be Disarmed using either the Remote Control or the Control Panel as follows:
Remote Control: Press the 'DISARM' button
?
?
?
,
Control Panel:
User Access Code
If the system is disarmed and the 'ALARM MEM' LED is flashing with the panel beeping every few
seconds, this indicates that an alarm condition has occurred. Use the Event Log to find out and make
a note of where the alarm occurred to assist in tracing the cause of the alarm.

05 - Quick Set

To operate the quick set function and fully arm the system in 5s, overriding the programmed exit
delay.
?
?
?
?
,
,
Press
User Access Code

06 - Omit Zone

To omit a zone from the next armed session:
?
?
?
?
,
,
1. Press
User Access Code
2. Scroll through the menu until the required zone is displayed. The current setting will also be
displayed.
3. To change the setting press
.
, ,
,
4. Press
to omit the zone, (i.e. zone omit ON). Press
omit OFF).
After configuring zones to be omitted as required, press
Note: Omitting a zone will only affect the next armed session. When the system is disarmed the
omitted zones will be re-enabled ready for the next armed session.
,
.
?
?
?
,
,
.
?
,
to re-enable the zone, (i.e. zone
to return to Standby mode.
ESC!
Page 02

07 - Panic Alarm

A full Alarm condition can be immediately initiated at any time (whether the system is Armed or
Disarmed) in the event of threat or danger by activating a Panic switch on either the Remote Control
or the Control Panel.
Remote Control: Slide the Panic switch upwards.
Control Panel: Press and hold the
The alarm will continue either for the alarm duration when the system will automatically reset or until
the system is disarmed.
08 - Tamper
If the battery cover of any device is removed or if the Siren or Control Panel are removed from the
wall then a Full Alarm condition will be initiated even if the system is Disarmed. The alarm condition
will continue either for the alarm duration when the system will automatically reset or until the system
is Disarmed. The 'ALARM MEM' LED on the Control Panel will flash and the panel will beep every
few seconds to indicate an alarm has occurred.
Note: The Tamper protection facility on the Siren operates independently. If the Tamper on the Siren
is activated this will not be indicated at the Control Panel.

09 - Chime

The Chime facility can only be operated with the system in Standby mode.
Press
to toggle the Chime facility between ON and OFF.
Note: If the Chime is ON and the system is then armed the Chime will remain ON after the system
is disarmed.

10 - Event Log

The Event Log will store the last 50 system Arm, disarm, alarm and detector Low Battery events.
The Event Log will record the time, date and details for each event. If when the system is disarmed
the "ALARM MEM' LED is flashing and the panel beeps every 10s, this indicates that an alarm has
occurred. To cancel the LED and stop the beeping you must access the event log or press
eliminate the flashing 'ALARM MEM' LED and the beeping as well.
1. To access the Event Log, (with the system in Standby), press
The Event-Log will automatically start scrolling through and displaying the event data starting
with the most recent event. The data for each event is shown on two screens, each screen will be
displayed for 5 seconds before moving on to the next screen and then the next event.
2. Use the
and
as necessary.
3. Press
to return to standby.
ESC!
button for approximately 3 seconds.
.
buttons to manually scroll through the event log to the required position
Page 03
to
ESC!