21st Century Alarms LuxHome LCD Podręcznik użytkownika - Strona 3
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla System bezpieczeństwa 21st Century Alarms LuxHome LCD. 21st Century Alarms LuxHome LCD 7 stron. Wireless alarm system
Drukuj stronę11 - Voice Dialer
If the Voice Dialer is enabled and an alarm condition occurs, the system will call for help using your
recorded alarm messages and up to four telephone numbers.
When an alarm condition occurs, the telephone voice dialer (if enabled) will call the first enabled
number in the calling sequence and replay the recorded alarm messages for the configured 'Play
Time'. The recipient must acknowledge the message by pressing the
keypad. If the call is unanswered or an acknowledgment is not received then the next active number
in the dialing sequence will be called. The dialer will continue calling each number in turn until either
all numbers in the sequence have been dialed the set number of times or the sequence is cancelled/
acknowledged by the recipient.
12 - Latch Key
When the system is disarmed the Latch-Key facility, if enabled, will call the first latchkey phone
number and replay the user message (recorded under user setup) for the set 'Play Time'. The
recipient must acknowledge the message by pressing the
call is unanswered or an acknowledgment is not received then the second latchkey phone number
will be called. The voice dialer will continue calling each number in turn until each number has been
dialed the set number of times or the sequence is cancelled/acknowledged by the recipient.
13 - Remote System Control
If the Remote System Control facility is enabled, the Control Panel will answer the call after the set
number of rings and emit three beeps on the phone line to prompt for a User Password to be entered
using the telephone keypad.
A valid User Password will be acknowledged with one long beep. An incorrect code will be
acknowledged by two short beeps. If the User Password is not entered within 30s or is entered
incorrectly three times then the Control Panel will automatically hang-up the line.
Note: If the internal Answer-Phone is also enabled and there is space for a new message then
the call will be answered with the Answer-Phone greeting message. The User Password should
be entered during the greeting message, otherwise the answer phone message recorder will be
activated.
#
By pressing the
button on the telephone keypad within 30 seconds, the Control Panel will
automatically hang-up the line.
Use with an External Answer-Phone:
If the Remote System Control is to be used in conjunction with an external Answer-Phone then:
1. The internal Answer-Phone must be disabled.
2. The number of 'ring to answer' for the Control Panel must be greater than that of the External
Answer-Phone, otherwise the Control Panel will always pickup the call before the Answer-
Phone.
Page 04
button on their telephone
button on the telephone keypad. If the
13 - Remote System Control
To access the Remote System Control facility the Control Panel has a 'double dial-in' feature to
enable the Control Panel to pick-up the phone call before the external Answer-Phone cuts in. T h e
'double dial-in' procedure is as follows:
1. Dial up the system and hang up after two rings.
2. Redial up the system within 24s as maximum (12s as minimum), the system will pickup the phone
after 1 ring.
3. Enter the User Password as normal.
The following functions may be accessed via the remote. The system will acknowledge each signal
with a single long beep.
Press
1
to initiate ARM.
Press
2
to initiate Part-Arm 1.
Press
3
to initiate Part-Arm 2.
Press
4
to Disarm the system.
5
Press
to turn the Siren OFF.
Press
6
to turn the Siren ON.
7
Press
to Listen-In via the Control Panel Microphone.
Press
#
to stop Listen-In.
Note: Listen-in will be automatically cancelled after 5 minutes if not cancelled manually.
Press
8
to interrogate the system status. The status tone will be repeated at 2s intervals for 15s:
One beep: ARM
Two beeps: Part-Arm (1 or 2)
Three beeps: Alarm triggered
Four beeps: Fire triggered
One long beep: Disarmed
Press
9
to replay Answer-Phone messages.
#
While replaying a message, press
for 2 seconds to skip to the end of the message and hear
the next message.
0
Press
to delete all Answer Phone messages.
Press
#
to end the session and hang up the Control Panel line.
Page 05