Cisco ATA 186 Konfiguracja - Strona 26

Przeglądaj online lub pobierz pdf Konfiguracja dla Gateway Cisco ATA 186. Cisco ATA 186 28 stron. Analog telephone adaptor
Również dla Cisco ATA 186: Arkusz danych (7 strony), Przegląd (11 strony), Podręcznik przeglądowy (11 strony), Podręcznik konfiguracji (8 strony), Podręcznik użytkownika (12 strony), Instrukcja instalacji i konfiguracji (13 strony), Instrukcje dotyczące instalacji (6 strony), Konfiguracja (6 strony)

Cisco ATA 186 Konfiguracja
• If there is no dial tone, make sure that the telephone line
cord from the telephone is plugged into the appropriate
port on the Cisco ATA. Make sure that your Cisco ATA is
properly registered on your Call Control system. Test
another phone; if this phone does not work either, there
may be a problem with the current configuration or with
the Cisco ATA.
• A busy tone indicates that the party you called is not
available. Try your call again later. A fast-busy tone
indicates that you dialed an invalid number.
• After power up, if the function button continues to blink
slowly, the Cisco ATA cannot locate the DHCP server.
Check the Ethernet connection and the availability of the
DHCP server.
• The DHCP server should show an incoming request from
the MAC address listed on the product label or given by the
voice prompt.
Customers who obtained their equipment through
Note
service providers, independent dealers and other third
parties must contact their equipment provider for
technical assistance.
26