Bosch DISHWASHER Manual de instruções de instalação - Página 7

Imprimir página

Bosch DISHWASHER Manual de instruções de instalação

30"

(762mm)

21"

(533mm)

Figure 4

Dishwasher Electrical Rating

l o

s t

z t

3" - 4"

(76mm - 102mm)

3/8" - 1/2"

(10mm - 13mm)

Figure 5

Electrical Preparation

e r

t a

s t

4 ,

(

) x

ELECTRICAL PREPARATION

WARNING

Electrical Shock Hazard

To avoid electrical shock, do not work on an

energized circuit. Doing so could result in serious

injury or death. Only qualified electricians should

perform electrical work. Do not attempt any work

on the dishwasher electric supply circuit until you

are certain the circuit is

de-energized.

WARNING

Fire Hazard

To avoid a fire hazard, make sure electrical work

is properly installed. Only qualified electricians

should perform electrical work.

Electrical Supply

The customer has the responsibility of ensuring that the

dishwasher electrical installation is in compliance with all

national and local electrical codes and ordinances. The

dishwasher is designed for an electrical supply of 120V,

60 Hz, AC, connected to a dishwasher-dedicated,

properly grounded electrical circuit with a fuse or breaker

rated for 15 amps. Electrical supply conductors shall be a

minimum #14 AWG copper wire rated at 75°C or higher.

Regardless of where the electrical supply cable enters the

enclosure, position the cable 21" (533mm) from the

enclosure's left side, as shown in Figure 4. Extend the

cable 30" (762mm) from the enclosure's back, as shown

in Figure 4.

Remove 3" - 4" (76mm - 102mm) of the cable's outer

casing, as shown in Figure 5, then remove 3/8" - 1/2"

(10 - 13mm) of insulation from each wire, as shown in

Figure 5.