Bosch DISHWASHER Manual de instruções de instalação - Página 8

Imprimir página

Bosch DISHWASHER Manual de instruções de instalação

Shut off

Valve

14"

(356mm)

Hot Water

Supply

Line

Figure 6

Plumbing Preparation

PLUMBING PREPARATION

To avoid being scalded, do not perform any work

on a charged hot water line. Serious injury could

result. Only qualified plumbers should perform

plumbing work. Do not attempt any work on the

dishwasher hot water supply plumbing until you

are certain the hot water supply is shut off.

Temperatures required for soldering and sweating

will damage the dishwasher's base and water inlet

valve. If plumbing lines are to be soldered or

sweated, keep the heat source at least 6 inches

(152.4 mm) away from the dishwasher's base and

water inlet valve.

Hot Water Supply

The hot water heater should be set to deliver

approximately 120° F (49° C) water to the dishwasher.

Water that is too hot can cause some detergents to lose

effectiveness. Lower water temperatures will increase run

times. The hot water supply pressure must be between

15 - 145 psi (1 - 10 bar).

Hot Water Supply Plumbing

Install an easily accessible shut-off valve (not supplied) in

the hot water supply line, as shown in Figure 6. All solder

connections must be made before the water line is

connected to the dishwasher's water inlet valve. Water

may also be supplied to the dishwasher by using a

stainless steel braided hose approved for dishwasher use.

Check with your local plumbing supply sources for the

proper hose and 90° elbow fitting.

NOTE: Regardless of where the hot water supply line

enters the enclosure, position the line 14" (356mm) from

the enclosure's left side, as shown in Figure 6.

NOTE: Decide whether stainless steel braided hose

approved for dishwasher use or copper tubing will be used

for the hot water supply plumbing, and purchase the

correct type of hot water supply shut-off valve, 90° elbow,

and necessary fittings for the hot water supply plumbing.

WARNING

Scald Hazard