HP ProCurve 1600M Kurulum Kılavuzu - Sayfa 4

Anahtar HP ProCurve 1600M için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. HP ProCurve 1600M 12 sayfaları. Redundant power supply
Ayrıca HP ProCurve 1600M için: Şartname Sayfası (12 sayfalar), Önce Beni Oku (8 sayfalar), İnceleme El Kitabı (27 sayfalar), Tamamlayıcı Kılavuz (2 sayfalar), Tamamlayıcı Kılavuz (2 sayfalar), Kurulum Kılavuzu (28 sayfalar), Kurulum Kılavuzu (36 sayfalar), Kurulum Kılavuzu (28 sayfalar), Hızlı Kurulum Kılavuzu (2 sayfalar), Hızlı Kurulum Kılavuzu (4 sayfalar), Kullanıcı Kılavuzu (8 sayfalar), Kılavuz Eki (28 sayfalar), Önce Beni Oku (16 sayfalar), Kurulum ve Sökme (2 sayfalar), Planlama ve Uygulama Kılavuzu (40 sayfalar), Ürün Kullanım Ömrü Sonu Sökme Talimatları (2 sayfalar), Kurulum Kılavuzu (46 sayfalar), Teşhis Kılavuzu (2 sayfalar), Sökme Talimatları (2 sayfalar)

Installing the Replacement Fan Tray

Overview

The installation steps are:

1. Disconnect all AC power from the switch and remove any power supplies and

cover plates.

2. On the front of the switch, mark or otherwise note the location of the network

cables attached to the network modules in switch slots A and B so that you can

reconnect the cables to the correct ports at the end of this procedure. Then,

disconnect all network cables from modules that are installed in slots A and B

on the front of the switch.

Alternatively, if you have sufficient slack in the cables, you can leave the network

cables connected to the modules as you complete the next step.

3. Remove the Management module and any modules that you have installed in

slots A and B. (Remember which module is located in which slot).

4. Remove the old fan tray assembly.

5. Install the Replacement Fan Tray.

6. Reinstall the Management module into its slot and the network modules into

their previous positions in slots A and B. (Make sure you do not overtighten the

screws on the modules.)

7. If you disconnected the network cables in step 2, reconnect the cables to the

correct ports on the network modules.

8. On the back of the switch, reinstall the power supply or supplies and cover plates.

9. Reconnect the AC power to the power supplies.

10. Verify that the switch is operating correctly by observing the LEDs on the front

of the switch.