3D Systems CUBE Kullanıcı Kılavuzu - Sayfa 15
3D Yazıcılar 3D Systems CUBE için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. 3D Systems CUBE 20 sayfaları. Replacing the print tip
Ayrıca 3D Systems CUBE için: Dokümantasyon (8 sayfalar), Ders (15 sayfalar)
Sayfayı Yazdır
4.
When prompted, tighten the lock screw enough to ensure the adjustment knob does
not easily turn. Select the
Caution: Do not over-tighten the lock screw. This can damage the adjustment
knob and void the manufacturer's warranty.
5.
Reinstall the print pad and select the
again.
NOTE: Select
that
Auto Level procedure
6.
Once Auto Level is successful, the printer will begin checking the Z-gap.
NOTE: The printer will perform an automated gap measurement. This may
take a few minutes.
checkmark
SKIP
to bypass the Auto Level procedure. It is recommended
is performed again.
to continue.
checkmark
to perform the Auto Level procedure