Centrica Panoramic Power PAN-10 Installation Manual - Page 11
Browse online or download pdf Installation Manual for Accessories Centrica Panoramic Power PAN-10. Centrica Panoramic Power PAN-10 11 pages.
Print PagePAN-10 and PAN-12 Sensor installation guide
Troubleshooting
If you encounter a problem, first try the following solutions:
Problem
The sensor is vibrating
The sensor is not sending measurements
Support
More support can be obtained at
Revision 1.4 January 2018
© 2018 Centrica plc. Registered office: Millstream, Maidenhead Road, Windsor, Berkshire. SL4 5GD.
Registered in England & Wales No 3033654
Solution
Make sure that the sensor is completely
closed (all four pins/screws are in place).
If they are, try pressing the sensor again
like you did when closing it.
Make sure the circuit has current.
Make sure that the sensor arrow points
in the direction of the load.
Make sure the sensors are near enough
to the bridge for the bridge to receives
its signals.
Check the reception LED of the bridge.
If it is not blinking it means that it is
not receiving signals.
11