Centrica Panoramic Power PAN-10 Installation Manual - Page 7

Browse online or download pdf Installation Manual for Accessories Centrica Panoramic Power PAN-10. Centrica Panoramic Power PAN-10 11 pages.

PAN-10 and PAN-12 Sensor installation guide

Mapping the site

See 'Panoramic Power deployment guide'.

Installing a sensor

This process is divided into two stages:
1. Physically attaching the sensors to the circuit wires;
2. Registering the installation in Panoramic Power System.

Attaching the sensors to the circuits

To install a sensor, follow these steps:
1. Open the cover of the electrical panel board.
2. Make sure you have a plan that indicates the circuits to be monitored
and the sensor IDs associates with each such circuit. Identify the circuit
breaker on which you would like to install the sensor.
The ID appears on the label fixed to the sensor.
3. Pick a sensor and slide the opener into position from the labeled side
towards the cover.
4. Snap the opener's pins into the four holes (in 225A unscrew the cover).
Figure 4. Slide opener into position
Revision 1.4 January 2018
© 2018 Centrica plc. Registered office: Millstream, Maidenhead Road, Windsor, Berkshire. SL4 5GD.
Registered in England & Wales No 3033654
7