Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Troubleshooting Manual - Page 8

Browse online or download pdf Troubleshooting Manual for Switch Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 11 pages. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Also for Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion: Installation Note (14 pages), Solution Manual (17 pages), Installation Note (46 pages), White Paper (19 pages), Description (1 pages), Product Bulletin (6 pages), Notice (4 pages), Datasheet (9 pages), Datasheet (18 pages), White Paper (18 pages), Configuration Manual (8 pages), Installation Note (28 pages), Installation Note (18 pages), User Manual (17 pages), Installation Note (24 pages), Manual (19 pages), Installation Note (36 pages)

Print Page
Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Troubleshooting Manual
MWAM System Error Messages
Error Message

NVRAM Error Messages

Error Message %MWAM_NVRAM-3-ERR:
Error Message MWAM_NVRAM-5-INFO: "%s"
Error Message %MWAM_NVRAM-5-KRUSTY_NVRAM_NOT_FOUND:

FUR Error Messages

Error Message %MWAM_FUR-3-ERR: "%s\n"
Multiprocessor WAN Application Module User Guide
B-8
MWAM_FLASH-3-FLASH_LOCKED_BY_OTHER_CPU: "%s"
Explanation
The other CPU within this complex is programming the shared flash, flash
programming must complete before proceeding with reload
Recommended Action
Wait for the other CPU to complete its flash programming operation, then
reenter the CLI command.
An error occurred while saving/erasing the configuration from flash.
Explanation
Copy the error message exactly as it appears, and report it to your technical
Recommended Action
support representative.
Information showing the state of the NVRAM configuration in the BootFlash.
Explanation
If this message recurs, copy the error message exactly as it appears on the
Recommended Action
console or in the system log. Research and attempt to resolve the error using the Output Interpreter
"OUTPUT_INTERPRETER." Also perform a search of the Bug Toolkit "BUG_TOOLKIT." If you
still require assistance, open a case with the Technical Assistance Center via the Internet
"TAC_CASE_OPEN," or contact your Cisco technical support representative and provide the
representative with the gathered information.
Information indicating there is no NVRAM pointer.
Explanation
Recommended Action
This indicates either NVRAM has not initialized properly, or it is corrupted.
An error occurred while upgrading or invalidating the Field-Upgradeable ROMMON.
Explanation
Copy the error message exactly as it appears, and report it to your technical
Recommended Action
support representative.
"%s"
"%s"
Appendix B
Troubleshooting
OL-7469-04