HP StorageWorks 1000 - Modular Smart Array 네트워크 매뉴얼 - 페이지 3

{카테고리_이름} HP StorageWorks 1000 - Modular Smart Array에 대한 네트워크 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP StorageWorks 1000 - Modular Smart Array 8 페이지. Power supply, computer
HP StorageWorks 1000 - Modular Smart Array에 대해서도 마찬가지입니다: 지원 목록 (34 페이지), 오류 방지 매뉴얼 (12 페이지), 기술 백서 (12 페이지), 펌웨어 업데이트 (9 페이지), 개요 (20 페이지), 설치 매뉴얼 (2 페이지), 지원 전화번호 (19 페이지), 참조 매뉴얼 (48 페이지), 관리 매뉴얼 (40 페이지), 릴리스 노트 (13 페이지), 빠른 시작 지침 (8 페이지), 빠른 시작 매뉴얼 (7 페이지), 릴리스 노트 (5 페이지), 교체 지침 (4 페이지), 백서 (13 페이지), 기술 개요 (15 페이지), 빠른 사양 (17 페이지), 사양 (49 페이지), 시작하기 매뉴얼 (34 페이지), 설치 (4 페이지), 설치 매뉴얼 (18 페이지), 분해 지침 매뉴얼 (9 페이지), 프로그래밍 매뉴얼 (8 페이지)

Set up the hardware and software

Now that you have the necessary components to get started, you're ready to

connect the pieces of the network and to configure the wireless router.

Set up and turn on the computer according to the instructions included with the computer. Ensure

that the computer is connected to AC power during this setup.

Make sure that the blue wireless light next to the wireless

icon

is off. If the light is on, turn it off by pressing the

wireless on/off button.

Important: If you encounter problems at any time during the router

setup, contact your router manufacturer for technical assistance.

Connect the wireless router according to the manufacturer's instructions. (During this process your

computer is temporarily connected to the router using the Ethernet cable included with the router.

The router instructions will tell you when to connect and disconnect the cable.)

Router Ethernet Cable

(shown in green)

Network connections with router Ethernet cable temporarily connected (jack locations vary)

Configure the wireless router according to the manufacturer's instructions. Refer to the information

you recorded in the "My Network Settings" table on page 2.

During router configuration, check whether the wireless router security level is set to Disable, WEP,

or WPA-PSK. Record this information in the "My Router Security Level" table on page 2.

Test the Internet connection by opening your Web browser and accessing a Web site. After you

have tested your setup with the wireless router Ethernet cable connected, remove the cable from the

computer and the wireless router.

DSL Modem

Wireless Router

Cable Modem

Location of the

wireless button

and light varies

by model.

Internet

PROGRESS CHECK

If you successfully complete

step 6, your router is set up

correctly. If you cannot access

a Web site, repeat steps 1

through 5, or contact your

router manufacturer or your

ISP for technical assistance.

Do not continue with these

instructions until you can

successfully access a

Web site.