Ricoh S7 D3DS 현장 서비스 매뉴얼 - 페이지 12
{카테고리_이름} Ricoh S7 D3DS에 대한 현장 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ricoh S7 D3DS 23 페이지. Double-feed kit
페이지 인쇄
1.Install
4.
Make sure there is no slack in the harness cables between their connectors and the clamp.
5.
At the back of the machine, set the double-feed sensor board below the edge of the ADF control board, and then
use a short screwdriver to fasten the sensor board.
6.
Connect the end of the short harness to the ADF control board [A].
7.
Gather the long harnesses [B] away from the back of the machine.
8.
At the back of the ADF, working from the left, open and close each clamp over both harnesses. Make sure that
10