3D Systems Cubify CUBEX Duo Değiştirme Kılavuzu - Sayfa 12
3D Yazıcılar 3D Systems Cubify CUBEX Duo için çevrimiçi göz atın veya pdf Değiştirme Kılavuzu indirin. 3D Systems Cubify CUBEX Duo 13 sayfaları. Replacing a main board pcb
Ayrıca 3D Systems Cubify CUBEX Duo için: Değiştirme Kılavuzu (17 sayfalar), Manuel (10 sayfalar), Manuel (10 sayfalar)
Sayfayı Yazdır
Fastening the print tip on a CubeX
A CubeX with a single print jet does not have a second or third nozzle to reference
the print tip level. Instead you have to use the CubeX wiping stick.
1. Power on the CubeX printer
2. Put the CubeX into manual move.
3. Raise the print pad until it is approximately 5mm away from the print tip.
4. Slowly raise the print pad until the print tip is touching it.
5. Continue raising the print pad until there is approximately 0.5mm between the
print pad and the CubeX wiping stick.
12