3D Systems Cubify CUBEX Duo Manual Penggantian - Halaman 12
Jelajahi secara online atau unduh pdf Manual Penggantian untuk Printer 3D 3D Systems Cubify CUBEX Duo. 3D Systems Cubify CUBEX Duo 13 halaman. Replacing a main board pcb
Juga untuk 3D Systems Cubify CUBEX Duo: Manual Penggantian (17 halaman), Manual (10 halaman), Manual (10 halaman)
Halaman Cetak
Fastening the print tip on a CubeX
A CubeX with a single print jet does not have a second or third nozzle to reference
the print tip level. Instead you have to use the CubeX wiping stick.
1. Power on the CubeX printer
2. Put the CubeX into manual move.
3. Raise the print pad until it is approximately 5mm away from the print tip.
4. Slowly raise the print pad until the print tip is touching it.
5. Continue raising the print pad until there is approximately 0.5mm between the
print pad and the CubeX wiping stick.
12